Chapter 3 Brake Tools, Shop Equipment, and Service Information 49 Copyright by Goodheart-Willcox Co., Inc. 1. Technician A says that a fl are-nut wrench is used to open brake bleeder valves. Technician B says that fl are- nut wrenches are sometimes called tubing wrenches. Who is right? (A) A only. (B) B only. (C) Both A and B. (D) Neither A nor B. 2. All of the following tools are used to service brake hydraulic system tubing, except: (A) bleeder wrench. (B) tubing cutter. (C) reamer. (D) mechanical bender. 3. Brake adjusters are used to adjust _____ brakes. (A) drum (B) disc (C) parking (D) mechanical 4. Technician A says that Allen and Torx are two types of recessed head bolts. Technician B says that Allen and Torx bolts require special bits for removal. Who is right? (A) A only. (B) B only. (C) Both A and B. (D) Neither A nor B. 5. C-clamps can be used to perform all of the following, except: (A) press out rivets. (B) pressing caliper pistons. (C) installing pins. (D) bleeding brakes. 6. Hones can be used to clean up all of the following, except: (A) wheel cylinders. (B) caliper bores. (C) hose fi ttings. (D) master cylinders. 7. Th e only sure way to measure brake drum diameter is by using a _____. (A) shoe and drum gauge (B) micrometer (C) dial indicator (D) Both A and B. ASE-Type Questions—Chapter 3 8. A clear jar and rubber hoses are oft en used to make the job of _____ brakes easier and cleaner. (A) adjusting (B) removing (C) installing (D) bleeding 9. A pressure bleeder can be operated by air pressure or with a(n) _____. (A) hand pump (B) foot pump (C) electric pump (D) All of the above. 10. Technician A says that a vacuum bleeder is hand operated. Technician B says that the master cylinder reservoir should be carefully monitored while vacuum bleeding. Who is right? (A) A only. (B) B only. (C) Both A and B. (D) Neither A nor B. 11. Technician A says that disc brake rotors can be turned without removing them from the vehicle. Technician B says that brake drums can be turned without removing them from the vehicle. Who is right? (A) A only. (B) B only. (C) Both A and B. (D) Neither A nor B. 12. A brake drum grinder is used to remove _____ aft er turning. (A) scoring (B) hard spots (C) oily spots (D) wheel studs 13. Technician A says that burnishing is performed to brake drums aft er turning. Technician B says that shoe grinding is performed to remove excess lining material. Who is right? (A) A only. (B) B only. (C) Both A and B. (D) Neither A nor B.