Copyright Goodheart-Willcox Co., Inc. Unit 6 Section Views 143 Print AP-009 10. on the cutting-plane line, what type of section is Section A-A? _Based __________________________________________________________________________________________________ Print AP-010 11. type of section describes this one-view drawing? _What __________________________________________________________________________________________________ Print AP-011 12. print features a section view labeled SECTION A-A. In this particular case, is this label necessary? _This __________________________________________________________________________________________________ Print AP-012 13. What type of section is featured on the main front view of this object? _ __________________________________________________________________________________________________ Print AP-013 14. List the names of the two parts located on the central cutting plane that are not shown as cut, but are instead still shown whole. _ __________________________________________________________________________________________________ 15. there any section lines on this part that are material specific? _Are __________________________________________________________________________________________________ Print AP-016 16. What type of section is featured to show the hole on the worm gear end of this part? _ __________________________________________________________________________________________________ Print AP-017 17. conventional practice is applied to the full section view with respect to the gear tooth? _What ___________________________________________________________________________________________________ __________________________________________________________________________________________________ Print AP-018 18. the section views shown on this print, are there any revolved or aligned sections? _For __________________________________________________________________________________________________