Copyright by Goodheart-Willcox Co., Inc.
308 Manual Drive Trains and Axles
9. When replacing a CV joint boot, which of the follow-
ing should be placed on the CV axle shaft first?
(A) CV joint.
(B) Large boot clamp.
(C) Small boot clamp.
(D) Lubricating grease.
10. Each of the following could occur if a CV joint boot is
improperly installed except:
(A) rapid wear of the CV joint.
(B) CV joint noises.
(C) loss of lubricant.
(D) transaxle failure.
11. Technician A says that on some vehicles, the front-end
alignment must be checked after the wheel bearings
are serviced. Technician B says that some stub shaft
nuts are held in place by a cotter pin. Who is right?
(A) A only.
(B) B only.
(C) Both A and B.
(D) Neither A nor B.