Chapter 9 Vehicle Maintenance, Fluid Service, and Recycling 155 Copyright Goodheart-Willcox Co., Inc. Review Questions Answer the following questions using the information provided in this chapter. 1. List the six aspects of lubrication service. 2. _____ includes any operation that will keep the car in good operating condition. 3. When checking engine oil, allow the engine to cool completely. True or False? 4. What can happen when too much oil is added in an engine? 5. Which of the following should not be done when changing an engine’s oil and filter? (A) Torque the drain plug only enough to prevent leaking and loosening. (B) Use an oil filter wrench to remove the old filter. (C) Wipe clean engine oil on the new filter O- ring seal. (D) Use an oil filter wrench to tighten the new oil filter. 6. The automatic transmission dipstick is normally located in front of the engine. True or False? 7. Check automatic transmission or transaxle fluid with the engine running. Check engine oil with the engine off. True or False? 8. Explain how to check the following: (A) Engine coolant level and condition. (B) Power steering fluid. (C) Brake fluid. (D) Manual steering fluid. (E) Battery condition. 9. A(n) _____ involves lubricating the steering, sus- pension, and drive train of a vehicle. 10. List and explain the use of five lubricants. 11. A(n) _____ is the amount of time between recom- mended service or maintenance operations. 12. Describe six general inspection points that should be checked during vehicle maintenance. 13. Which of the following should be done to help with leak detection and troubleshooting skills? (A) Become familiar with the color and smell of different fluids. (B) Trace the problem to the highest point of wetness or leakage. (C) Clean the area around the leak if the leak is difficult to isolate. (D) All of the above. 14. A(n) _____ is commonly used to find the source of noises inside parts. 15. List four automotive items that should be recycled. ASE-Type Questions 1. During a complete lubrication service, all of the following are done except: (A) change engine oil. (B) change oil filter. (C) check all fluid levels. (D) check ride height. 2. During an oil change, Technician A says to use an oil filter wrench to remove the old oil filter. Technician B says to apply a little oil to the seal on the new filter to aid installation. Who is correct? (A) A only. (B) B only. (C) Both A and B. D) Neither A nor B. 3. When changing engine oil, Technician A says the engine oil should be cool. Technician B says the oil should be warm. Who is correct? (A) A only. (B) B only. (C) Both A and B. (D) Neither A nor B. 4. When checking automatic transmission fluid, the following should be done. (A) Engine off, transmission in park. (B) Engine running, transmission in park. (C) Engine off, transmission in neutral. (D) Engine on, transmission in neutral.